Multiple Block Drawing Machine

Inclied Block Dry Drawing Machines:
The multiple block drawing machines have inclined axis drawing blocks and dancer arm speed synchronization for high-speed drawing of medium and fine-diameter wire.
Construction:
The bench framework, built in sturdy, electro welded plate steel, comes in one or more multiple-block section fitted with eye bolts to facilitate lifting, transport and installation. The capstan and relative die box, motors,brakes, safety guards, water feed drainage tubes etc. Are all pre-assembled on the bench.
Electrical Equipment:
All electrical, electro mechanical and electronic components come from leading suppliers and are available world wide.
The operating logic is achieved through a PLC, with an automatic diagnostic system.
Drawing Blocks:
The drawing blocks are made from hot annealed steel cast. Capstan pulling bands plasma hot coated with a tick layer of tungsten carbide are available.
Cooling:
Cooling water is fed to the drawing blocks and dies through two separate circuits.
Safety:
A pneumatic brake installed on each block to serve both as a parking brake and emergency brake.
Electrical safety switches make sure the machine can not be run if safety guards are open.
Motorization:
Each drawing block is driven by an IP55 A.C. motor, controlled by a driver. The motors have force cooling, thus available to good cool performance.
The reduction gears theoretical lifespan of 85.000 working hours.

Technical Specifications of the Multiple Block Drawing Machine:
Max.Inlet Diameter (mm): 15 - 8 mm
Inlet Tensile (N/mm): 1250
Finishing Range (mm): 8 - 3 mm
Number of Block: 3 - 14
Motor (kW): 132 AC

멀티 와이어 드로잉 머신

플랫 와이어의 되감기 기계

막대 내역 그리기 선