The bench framework, built in sturdy, electro welded plate steel, comes in one block section fitted with eye-bolts to facilitate lifting, transport and installation. The motors, brakes, safety guards, water tank etc. are all pre-assembled on the bench.
The drawing capstan and rings are made of steel cast, and plasma hot coated with a tick layer of tungsten carbide are available.
AC motors controlled by direct torque control inverters are preferred for their numerous advantages (low maintenance, high power efficiency, and optimal speed regulations) power is transmitted by belts and pulleys to the drawing rings and capstan. Motors are mounted vertically at
the top of the bench Electrical safety switches make sure the machine cannot be run if safety guards are open.
All electrical, electro-mechanical and electronic components come from leading suppliers and are available world wide, including the DTC inverters for AC motor control, which are supplied by ABB.
The electrical equipment is lodged in dust-proof cabinets that can be opened from both the front and the back. The line energy analyzer is mounted on the front of the main cabinet.
Our wet wire drawing machine consists of pay-off, drawing unit, coating unit, dancer unit, and spooler.
High Speed Single / Double Wire Non-Slip Rod Breakdown Machine
High Speed Single/Double Wire Rod Breakdown Machine
Multiple Wire Intermediate Drawing Machine (8/10/14/16 wires)
High Speed Single / Double Wire Intermediate Drawing Machine
High Speed Single / Double Wire Non-Slip Intermediate Drawing Machine
High Speed Single Wire Intermediate Drawing Machine
Tandem Wire Intermediate Drawing Machine
High Speed Multiple Fine Wire Drawing Machine (8/10/14/16 wires)
High Speed Double Fine Wire Drawing Machine with Inline Annealer
High Speed Single Fine Wire Drawing Machine with Inline Annealer
